Using Lightfield; Define The Detector And Spectrograph - Teledyne Everywhereyoulook IsoPlane 320A Manual

Table of Contents

6.3 Using LightField

Launch LightField after verifying that the detector and IsoPlane are both connected to the

host computer and are turned on. When LightField boots it will look for available devices

and will load their icons in the

experiment or run an existing one, the appropriate device icons must be dragged into the

Experiment Devices

panel will be populated with expanders for groups of experiment settings.

6.3.1

Peform the following procedure to define a detector and spectrograph:

After LightField opens, an icon representing the detector should be visible within the

Available Devices

Figure 6-1: Typical LightField Available Devices Panel

Drag the desired icon into the

Available Devices

panel. Once there is at least one device, the

NOTE:

If the IsoPlane (320A) icon is the only device in the Experiment

Devices panel, the Spectrograph expander will be the only

expander in the list. When you drag a detector into the panel, the

Calibration expander and all of the detector- related expanders

will be displayed.

area. In

Figure

Experiment Devices

panel. Before you can design a new

6-1, the detector is a PIXIS:100B eXcelon

area. See

Experiment Settings

Figure

6-2.

Table of Contents