Table of Contents
Advertisement
16
Perform the following procedure to install a grating turret into an IsoPlane unit:
Locate the storage container with the grating turret that is to be installed.
1.
Using the 9/64" hex wrench, remove the four Turret Compartment cover screws and
2.
remove the cover. Become familiar with the grating turret and its components.
Before removing the grating turret from the shipping container, use a 3/32" hex wrench
3.
to loosen the three set screws on the bottom of the container (about 1 turn.)
Remove the cover from the shipping container, grasp the Center Torque Screw and turn
4.
it counter-clockwise until the turret can be lifted straight up. See
Figure 3-2: Center Torque Screw
!
CAUTION!
Observe proper optical handling procedures.
REFERENCES:
Refer to
Section 3.3, Turret
information about replacing one turret assembly with another.
Interchange, on page 21 for
C
S
Figure
3-2.
T
ENTER
ORQUE
CREW
Advertisement
Table of Contents
