Table of Contents
Advertisement
12
Chapter 2: VSpin Overview
VSpin User Guide
About Profiles
What You Need to
Know
More Information
In general, a profile is a collection of settings saved as a group that are
not lost when you close the software. In the case of the VSpin, the
settings stored in a profile are:
❑
Serial communications port
❑
Maximum spin speed
❑
Bucket tolerance
❑
Rehome after spin (not editable)
❑
Teachpoint for bucket position
❑
Motor settings (not editable)
These are the basic settings that you are unlikely to want to change for a
particular VSpin application once it has been set up. It is possible to
have multiple profiles for the same VSpin.
Example Use
If you have three centrifuges on your system, you would create three
different profiles (VSpin1, VSpin2 and VSpin3 for example). Then, to
perform a spin on the third centrifuge you would select the profile
VSpin3. The profile initializes communication with the device and
provides the basic settings. You then configure other settings for the
individual spins, such as velocity and total time.
For more information about profiles, see the following topics:
❑
"About the Profiles Page" on page 16
❑
"Creating and Managing Profiles" on page 37
❑
"Using Profiles" on page 49
Hide quick links:
Advertisement
Table of Contents
