Installation Overview - Agilent Technologies Velocity11 VSpin User Manual

22 Chapter 3: Installation
VSpin User Guide

Installation Overview

Installation
Procedures
The procedures you need to perform to properly install your VSpin are
listed in order in the following table.
Step Procedure
1. Verify that your lab meets the
necessary requirements
2. Unpack the VSpin
3. Install the buckets
4.
Prepare to install the VSpin
5. Install the VSpin
6. Connect air and power sources
7. Connect to the computer
8. Install the software
9. Create a Profile
10. Teach the bucket alignment so
that it lines up with the door
See...
"Laboratory Requirements" on
page 23
"Preparing the Mounting Surface"
on page 26
"Unpacking the VSpin" on
page 24
"Installing the Buckets" on
page 31
"Preparing the Mounting Surface"
on page 26
"Mounting the VSpin" on page 29
"Connecting to Air and Power
Sources" on page 33
"Connecting to the Computer" on
page 35
"Installing the Software" on
page 36
"Creating and Managing Profiles"
on page 37
"Aligning the Buckets" on page 40