Table of Contents
Advertisement
50
Chapter 4: Performing a Spin
VSpin User Guide
Closing a Profile
Where to Go Next
3. Check that the status lights start blinking on the Control and
Diagnostics pages while the VSpin homes, and that the VSpin door
opens when homing is complete.
If these events do not occur, or you receive an error at this point,
refer to the "VSpin Error Reference" on page 79.
When you close a profile, you end the serial communication session
between the VSpin and the computer.
You must close the currently running profile before you can open
another.
To close a profile:
1. Click the
tab at the top left of the
Control
The
page opens.
Control
2. Click
.
Close profile
The serial communication between the VSpin and the computer
ends.
The VSpin door closes and locks, and the buckets unlock.
Before you start a spin, refer to the "Workflow Overview" on page 46.
dialog box.
VSpin Control
Hide quick links:
Advertisement
Table of Contents
