What This Guide Covers - Agilent Technologies Velocity11 VSpin User Manual

Chapter 1: Introduction
VSpin User Guide
Damage hazards
Safety labels
!! DAMAGE HAZARD !!
or metal brushes to clean any VSpin components or accessories. Do not use
any concentration of bleach (sodium hypoclorite). Do not allow cleaning agents
to contact any electrical or sensitive mechanical components.
!! DAMAGE HAZARD !!
the plate fragments need to be removed so they do not interfere with moving
parts and potentially damage the VSpin.
!! DAMAGE HAZARD !!
screw, which fastens the rotor to the central motor axle. It is located on the
bottom of the rotor. Contact Automation Solutions Technical Support if you
think the rotor mounting screw requires maintenance. The VSpin is designed to
have a permanently attached rotor, unlike many manual centrifuges that can
have interchangeable rotors.
Warnings in the user documentation or on the device must be observed during
all phases of operation, service, and repair of this device. Failure to comply
with these precautions violates safety standards of design and the intended use
of the product. Agilent Technologies assumes no liability for the customer's
failure to comply with these requirements. The following table lists the
common symbols. A description of the warning and information that will help
you avoid the safety hazard are provided in this guide.
Symbol Description
Indicates that you must read the accompanying
instructions (for example, the safety guide) for more
information before proceeding.
Indicates hazardous voltages.
Indicates pinch, crush, and cut hazard.
Indicates laser hazard.
Indicates hot surface hazard.
Indicates protective conductor terminal, which is bonded
to conductive parts of an equipment for safety purposes.
Indicates that you must not discard this electrical/
electronic product in domestic household waste.
Do not use harsh abrasives, corrosive cleaning agents,
Plates occasionally break apart inside the VSpin, and
Do not tamper with or adjust the VSpin rotor mounting