Agilent Technologies Velocity11 VSpin User Manual page 69

00102
3. Make sure that the bucket is accurately aligned with the door.
00085
VSpin
bucket alignment
If the bucket is not aligned correctly, see "Teaching the Bucket
Position" on page 41.
4. Using the directions in "Setting the Presented Bucket" on page 55,
move the bucket that will contain the balance plate to the front and
place the balance plate on the bucket.
5. Move the bucket that will contain the sample plate to the front and
place the sample plate on the bucket.
Leave the
Bucket to present
the sample plate so that the sample plate is accessible for future
spins.
6. Check your motion settings, and change them if necessary.
See "Configuring Motion Settings" on page 51.
7. Click
Start spin cycle
page.
The spin cycle starts, using the settings specified.
8. To perform additional spins, replace the sample plate with another
one that is within 10 grams of the balance plate and click
again.
cycle
Towards spindle center
00102
VSpin
Bucket
selection set for the bucket that contains
from the group box of the
Execute
Chapter 4: Performing a Spin
VSpin User Guide
bucket
Control
Start spin
59