Startup Diagnostic Codes - Nortel CallPilot 201i Installation And Configuration Manual

Troubleshooting your CallPilot system

Startup diagnostic codes

Introduction
HEX display diagnostic codes are divided into the following two categories:
critical startup diagnostics
noncritical operating system and switch diagnostics
Critical startup diagnostic codes
All critical startup diagnostics must pass before the 201i can proceed with
the start sequence. If a critical diagnostic fails, the start sequence
indefinitely halts, an error code displays, and a continuous beep is heard.
The following table shows the critical startup diagnostic codes with their
corresponding failure codes. Failure of these diagnostics means that there
has been a server failure. The start cycle is halted.
Note: When a test is successfully completed, the next test code appears.
Test code
T:01
T:02
T:03
T:04
T:05
T:06
T:07
32
Test description
Internal RAM self-test
ALU self-test
Address mode self-test
Boot ROM self-test
Timer self-test
Watchdog self-test
EEPROM self-test
Standard 1.0
Failure code
F:01
F:02
F:03
F:04
F:05
F:06
F:07
CallPilot