Nortel CallPilot 201i Installation And Configuration Manual page 56

Using Windows NT online diagnostic tools
The ping command
The ping command sends an echo request to a specified host. Use this
command to verify network connectivity to the remote device.
Ping command syntax
The ping command uses the following syntax:
ping [-t] [-a] [-n count] [-l size] [-f] [-i TTL]
[-v TOS] [-r count] [-s count]
[[-j host-list] | [-k host-list]]
[-w timeout] destination-list
Parameter
-t
-a
-n count
-l size
-f
-i TTL
-v TOS
-r count
-s count
-j host-list
-k host-list
-w timeout
56
Description
Pings the specified host until interrupted.
Resolves addresses to host names.
Specifies the number of echo requests to send.
Sends buffer size.
Set Don't Fragment flag in packet.
Time To Live
Type Of Service
Record route for count hops
Time stamp for count hops
Loose source route along host list
Strict source route along host list
Time-out in milliseconds to wait for each reply
Standard 1.0
CallPilot