Interpreting The Hex Display - Nortel CallPilot 201i Installation And Configuration Manual

Troubleshooting your CallPilot system

Interpreting the HEX display

Introduction
This section describes the codes that can appear on the HEX display during
startup or normal 201i server operation.
Note: For a description of the codes that appear during startup diagnostics,
see "Startup diagnostic codes" on page 32. For a description of the startup
sequence, see "Startup sequence description" on page 36.
HEX display codes
During startup and normal 201i server operation, the HEX display on the
server faceplate displays one of the following codes:
HEX display output
Startup codes
T:XX
F:XX
26
Description
The 8051 controller is starting and running
diagnostics. These diagnostics are performed
during a cold restart (when the server is powered
up, or if you press Reset on the 201i server's
faceplate).
For more details, see "Startup diagnostic codes"
on page 32.
At least one diagnostic failed. The displayed error
code represents the first failed diagnostic.
For more details, see "Startup diagnostic codes"
on page 32.
Standard 1.0
CallPilot