Nortel CallPilot 201i Installation And Configuration Manual page 92

Maintenance and diagnostics
Hide thumbs Also See for CallPilot 201i:
Table of Contents

Advertisement

Using CallPilot Manager to monitor hardware
Component
MPCs (embedded on the IPE server
or on MPC-8 cards)
DSPs
Channels
DS30X link
Diagnostic tests available for each component
The diagnostic tests that are available for each component are listed in the
Diagnostic section of the Maintenance page. To view the list of diagnostic
tests for a particular component, click the component in the component tree.
If a diagnostic test fails or cannot be run
If a warning message appears, the diagnostic test cannot be run because a
prerequisite condition has not been met. If a diagnostic test fails, a message
appears in a new browser window (see the example on page 95).
In both cases, check the Alarm Monitor to determine the reason and the
appropriate action to take. (See "Tools for isolating and fixing hardware
problems" on page 67.)
If the Alarm Monitor and Event Browser do not provide a solution to a
hardware problem, you may need to replace or service a component. If the
problem is with a component that is not replaceable because it is not a
physical entity (such as the Time Switch), you must either replace its parent
component or contact your Nortel Networks technical support
representative, depending on the component.
92
Diagnostics
available?
Replaceable?
Yes
Embedded: No
MPC-8 cards: Yes
Yes
No
No
No
No
No
Standard 1.0
CallPilot

Advertisement

Table of Contents
loading

Table of Contents