Interpreting The Power Status Led - Nortel CallPilot 201i Installation And Configuration Manual

October 2002

Interpreting the power status LED

Introduction
The power status LED is located on the 201i server's faceplate, directly
under the keyboard connector. The LED indicates whether it is safe to
remove the server from the switch (which results in a server power down).
.
Power status LED functions
The LED indicates two server states:
The 201i server is in use.
It is safe to remove the 201i server from the switch.
Power status LED indications
IF the power
status LED is
on
Part 5: 201i Server Maintenance and Diagnostics
CAUTION
Risk of equipment damage or data loss
Do not remove the 201i server during normal operation or
certain phases of the startup sequence, as this can damage the
operating system files on the hard disk.
To determine if it is safe to remove the 201i server from the
switch, see "Power status LED indications" on page 21.
THEN
the server is powered on. It is safe to remove it from the
switch.
Note: When the LED is lit, the HEX display may display
one of the following: T:XX, F:XX, HOST, or DOWN.
Troubleshooting your CallPilot system
21