Nortel CallPilot 201i Installation And Configuration Manual page 34

Troubleshooting your CallPilot system
Status code
NT
CDLN
C:01
C:02
34
Operation description
Windows NT start sequence started
Note: If the CallPilot server
software is not installed, the HEX
display remains at NT. (This can
occur if you are performing a
system rebuild.) During CallPilot
software installation, the 8051
device driver is copied to Windows
NT, at which point the HEX display
continues as described below.
8051 device driver on Windows NT
has started; beginning of Cardlan
interface communication (DS30x
interface initialization)
The system controller
communicates with the switch,
indicating that two cards are
installed, and waits for switch
acknowledgement.
Initialization of the first DS30x
interface
Initialization of the second DS30x
interface
Standard 1.0
Failure code
P:XX
Note: For a description,
see "P:XX failure codes"
on page 35.
CDLN
Neither of the DS30x
interfaces were initialized
(both failed).
C:01
Initialization of the first
DS30x interface failed.
The second DS30x
interface is OK.
C:02
Initialization of the second
DS30x interface failed.
The first DS30x interface
is OK.
CallPilot