Nortel CallPilot 1002rp Installation And Configuration Manual page 97

October 2002
To run a diagnostic test
ATTENTION
1 In CallPilot Manager, click Maintenance
Result: The Maintenance page appears.
2 Click the plus sign (+) beside the CallPilot server to expand the
component tree.
3 Continue clicking the plus sign (+) until the component with which you
want to work is visible.
4 Click the hardware component for which you want to run diagnostics.
Result: The Maintenance page refreshes to show details about the
component.
5 Scroll down to the Maintenance section, and ensure that the component
is out of service.
Note: For instructions on taking the component out of service, see "To
start or stop a component" on page 93.
Part 5: 1002rp Server Maintenance and Diagnostics
Nortel Networks recommends that you courtesy stop rather
than stop a component if possible. For instructions, see
"Starting and stopping components" on page 91.
Using CallPilot Manager to monitor hardware
➝
Maintenance Admin.
97