Nortel CallPilot 1002rp Installation And Configuration Manual page 86

Using CallPilot Manager to monitor hardware
Section
Maintenance
Diagnostics
Maintenance activities for each component
The following table identifies the maintenance activities you can perform
for each component that is listed in the component tree:
Component
Media Bus
MPB board
86
Description
This section shows the state of the selected component. Use
this section to start and stop a component before running a
diagnostic test.
This section appears only for components on which you are
allowed to perform maintenance administration.
For more information about working with component
states, see the following sections:
"Viewing component states" on page 88
"Starting and stopping components" on page 91
Use the Diagnostics section to run one or more diagnostic
tests, or to view the results of the last diagnostic tests that
were run on the selected component.
This section appears only for components on which you are
allowed to run diagnostics.
For more information about running diagnostics, see the
following sections:
"Running integrated diagnostics" on page 95
"Viewing the last diagnostic results" on page 100
Start, stop, or
courtesy stop?
Yes
Yes
Diagnostics
available? Replaceable?
Yes No
Yes Yes
Standard 1.0
CallPilot