Nortel CallPilot 1002rp Installation And Configuration Manual page 48

Using Windows NT online diagnostic tools
Tracert parameters
The tracert command uses the following parameters:
Parameter
-d
-h maximum_hops Specifies the maximum number of hops to search for
-j host-list
-w timeout
target_name
To run the tracert command from Windows NT 4.0
1 Click Start
command prompt window.
Result: The MS-DOS Command Prompt window appears.
2 At the MS-DOS prompt, type the following command:
tracert [-d] [-h maximum_hops] [j host_list] [-w timeout] [target
name]
Example: tracert 200.286.0.32 210 200.236.0.04
3 Press Enter.
Result: The system runs the tracert utility.
4 Type Exit to exit MS-DOS and return to Windows NT 4.0.
48
Description
Specifies not to resolve addresses to hostnames.
the target.
Specifies a loose source route along the host list.
Waits the number of milliseconds specified by the
time-out for each reply.
The name of the target host.
➝ ➝
Programs Command Prompt to display the MS-DOS
Standard 1.0
CallPilot