Nortel CallPilot 1002rp Installation And Configuration Manual page 105

October 2002
Note: For an explanation of the channel states, refer to the CallPilot
Manager online Help.
2 Do one of the following:
IF you want to stop or start
all of the channels
associated with a DSP
only one or several
channels that are
associated with a DSP
3 Click Courtesy Stop, Stop, or Start as required.
Result: If you clicked Courtesy Stop or Stop, you are asked to confirm
the Courtesy Stop or Stop. Click OK.
The selected channels change to off-duty or on-duty status, according to
the action you chose.
Note: If the buttons are not available, wait a few seconds for the page to
refresh.
Part 5: 1002rp Server Maintenance and Diagnostics
Using CallPilot Manager to monitor hardware
THEN
check the check box to the left of the
DSP that you want to stop or start.
Repeat this step for each DSP.
check the check box for each
channel that you want to stop or
start.
105