Nortel CallPilot 1002rp Installation And Configuration Manual page 63

October 2002
To invoke the TSTSERIO /P command from Windows NT 4.0
1 Click Start
command prompt window.
Result: The MS-DOS Command Prompt window appears.
2 At the MS-DOS prompt, type tstserio with the required parameters, and
then press Enter.
For example, type TSTSERIO /P com1 or TSTSERIO /P com 2, and
then press Enter.
3 Type Exit, and then press Enter to exit MS-DOS.
TSTSERIO external loopback plug subtests
The following external loopback subtests are available for the TSTSERIO
command. For each of these tests, an external loopback connector must be
used. For more information, see "Conducting TSTSERIO tests with the
loopback plug" on page 65.
Subtest
name
edata
emsr
eint
Part 5: 1002rp Server Maintenance and Diagnostics
➝ ➝
Programs
Description
External data bus loopback. This test requires an external
loopback connector.
External modem status register. This test requires an
external loopback connector.
Test ability of device to generate interrupts. This test
requires an external loopback connector.
Using serial port diagnostic tools
Command Prompt to display the MS-DOS
63