Nortel CallPilot 1002rp Installation And Configuration Manual page 168

Maintaining an AMI MegaRAID Elite 1600 RAID system
Verifying BIOS and Firmware Revision
On the CallPilot 1002rp RAID controller, the BIOS and firmware revision
can be determined by powering on the server, and going into the RAID
CTRL+M utility under the Objects➝Adapter➝Adapter Information menu.
Upgrading the BIOS and firmware
ATTENTION
The BIOS of the CallPilot 1002rp system can be upgraded through a Flash
process (running a software utility), to facilitate easy upgrades. CallPilot
technology always institutes a minimum version on the BIOS in CallPilot
servers. The following table lists the minimum versions of the BIOS for the
SBC:
Note: If the BIOS of the server does not meet the minimum version, the
BIOS must be upgraded.
AMI RAID Elite 1600
BIOS
Firmware
To upgrade the server BIOS
1 Retrieve the CallPilot OS Installation CD.
2 Boot from the disk and follow the prompts to launch the RAID BIOS and
the firmware flash utility.
3 Choose Y for yes to confirm that the 471gen.rom file is detected, and
then program the BIOS and firmware.
4 Allow the flash process to complete.
5 Shut down the system.
168
This procedure should only be performed if the BIOS and
firmware version are not the ones documented.
Minimum version
3.11
D170
Standard 1.0
CallPilot