Nortel CallPilot 1002rp Installation And Configuration Manual page 199

October 2002
To replace the SBC card
.
1 Power down the server.
2 Disconnect the power cord.
3 Remove the top cover.
4 Disconnect and label all cables from the SBC card. See "SBC card
connectors and jumpers" on page 198.
Note: If necessary, refer to "Slot assignments" on page 212 to locate the
SBC card.
5 Disconnect and label cables from the SBC card faceplate.
6 Loosen and remove the screw that is securing the SBC card.
7 Loosen and remove the screw located at the top of the card's faceplate.
8 Loosen the SBC and pull it up from the backplane.
Note: You can now do the following:
Replace the SBC with a new card. To replace it, continue with step 9.
Increase RAM by adding DIMM(s) to the card. See "To add SDRAM
DIMMs to the SBC card" on page 204.
9 Remove the new card from its protective wrapping.
10 Align the card with its slot on the backplane and press it into place.
Result: The board seats properly in both the ISA-style and PCI-style
connectors.
11 Fasten the card down with the screw provided.
12 Install the new I/O bracket.
Part 5: 1002rp Server Maintenance and Diagnostics
DANGER
Risk of explosion
The SBC has a lithium battery installed. If you are discarding
the SBC, dispose of used batteries according to the
manufacturer's instructions. Replacement of the battery with
an incorrect type also raises the risk of an explosion.
Maintaining the Pentium III SBC card
199