Nortel CallPilot 1002rp Installation And Configuration Manual page 124

Replacing basic chassis components
To remove the server cover
.
.
1 Remove the front bezel (see page 123).
2 Power down the server and disconnect all power cords.
3 Loosen the three thumbscrews at the rear of the top cover.
4 Remove the server cover by pulling the cover toward the rear of the
chassis, and then lifting it up and off.
5 Clip the lead from your ESD wrist strap to an unpainted metal section of
the chassis.
124
DANGER
Risk of electric shock
High current inside the chassis can cause severe injury.
CAUTION
Risk of equipment damage
Take precautions to protect internal components. Electrostatic
discharge (ESD) can damage boards and make them unusable.
Wear an ESD wrist strap.
Standard 1.0
CallPilot