abc 2000 Series User Manual page 92

p
Output
protection selection
P9.13
S
e ng tti
It is used to determine whether to perform output phase loss
protection.
P9.14 1st fault type
P9.15 2nd fault .,.,,,., e
P9.16 3rd (latest) fault type
It is used to record the types of the most recent three faults of the
AC drive. O indicates no
fault. For possible causes and solution of each fault, refer to
Chapter 5.
P9.17 Frequency upon 3rd fault
P9.18 Currant upon 3rd fault
P9.19 Bus voltage upon 3rd fault
Input terminal status upon
P9.20
3rd fault
Output terminal status
P9.21
upon 3rd fault
AC
drive status upon 3rd
P9.22
fault
Power-on time upon 3rd
P9.23
fault
hase l�s
Ra
nge
1:Permitted
Detailed Function
Default
It displays the frequency when the latest
fault occurs.
It displays the current when the latest
fault occurs.
It displays the bus voltage when the
latest fault occurs.
It displays the status of all input
terminals when the latest fault occurs.
The sequence is as follows:
If an input terminal is ON, the setting
is 1, the OFF is 0, the setting is
value is the equivalent decimal number
converted from the
It displays the stab.Js of all output
terminals when the latest fault occurs.
The sequence is as follows:
BIT2
BlT3 I
'"'
RA,RB,RC
If an output terminal is ON, the setting
1,
is the OFF is 0. If the output terminal
is OFF, the setting is
equivalent decimal number converted
from the S statuses.
Reserved
It displays the present power-on time
when the latest fault occu r s.
0-99
S4 S2
0.
S
status.
YO
O.
The value is the
The