List of Function Parameters
to
If PP.00 is set
enabled. You must enter the correct user password to enter the
menu. T o cancel the password protection function, enter with
password and set PP.00 to 0.
Parameters menu the user customizes are not protected by
password.Group P is the basic function parameters , Group D is to
monitor the function parameters. The symbols in the function code
table are described as follows:
"*":
The parameter can be modified when the AC drive is in either
stop or running state.
"*":
The parameter cannot be modified when the AC drive is in the
running state.
The parameter is the actually measured value and cannot be
"•":
modified.
The parameter is factory parameter and can be set only by the
"*":
manufacturer.
Standard Function Parameters
Function
Parameter
Code
Name
PO:
Group
St.nd•rd Function P•rmmet.rs
GIP
P0.00
type display 2: P type (variable torque
Control mode
P0.01
selection
Appendix A
a non-zero number, parameter protection is
Setting Range
1: G type (conslant torque load)
fan and
pump)
O:Voltage/Frequency (V/F)
control
1 :Sensor1ess
control
1
·
load
e.g.
ftux
vector
3
0
·
Default
Property
*
Model
dependent
*
0