abc 2000 Series User Manual page 56

must be set to determine the setting output voltage.
7: PID
The output voltage generates based on PID closed loop. For details,
see the descriptions of PID in group PA.
8: Communication sett i ng
The output voltage is set by the host computer by the means of
communication given.
The voltage source for V/F separation is set in the same way as the
frequency souroo.100.0% of the setting in each mode corresponds
to the rated motor voltage. If the corresponding value is negative, its
absolute value is used.
Voltage r1se time
separation
P4.15
Setting Range
Voltage dedlne time of
VfF separation
P4.16
Setting Range
P4.15 indicates the time required for the output voltage to rise from
O V to the rated motor voltage shown as t1 in the following figure.
P4.16 indicates the time required for the output voltage to decline
from the rated motor voltage to 0 V, shown as
figure.
Output voltage
Group P5: Input Terminals
MT-2
0 0 0 series inverter with 6 multi-function digital inputs {S3 can
V/F
of
voltage riJring time
Set
ure 4m7
F g Voltage of V/F separation
i
Detailed Function
Default
O.Os-1000.0s
Default
O.Os-1000.0s
Set voltage declining time
t2
in the following