abc 2000 Series User Manual page 184

and inverter.Notice that setting the baud rate of upper machine
and inverter must agree, otherwise, the communication can't carry
on.The faster the baud rate, the greater the communication.
PD.01
PC and data format set by the inverter must agree, otherwise, the
communication can't carry on.
PD.02
When the machine address set to 0, namely for the broadcast
address, realize PC broadcasting functions.
The machine address has uniqueness (except the broadcast
address), which is to achieve the basis of upper machine and
inverter peer-to-peer communications.
PD.03
Response latency: refers to the inverter data to accept the end up
to a upper machine to send data in the middle of the interval of time.
If the response time delay is less than the system processing time,
the response time delay will
processing time, such as response time delay is longer than system
after processing the data, the system will delay waiting, until the
response delay time to up to a upper machine to send data.
PD.04
When the function code is set to 0.0 s, communication timeout
parameter is invalid.
When the function code set to valid values, if a communication
and the interval time of the next communication beyond
the communication timeout, system will be submitted to the
communication failure error {CE),Usual!y, it is
the continuous communication system parameter sat the time, you
can monitor the communication status.
The
data format
setti n g range
The m ch ne The factory val u e
a
i
address
laten
Response
be
m n tio
Com ca
u
i n
timeout
i
e g e
s
tt
n n
g
ra
B Communication Protocol
The factory val u e
check: T he
O:No
: E ven-parity: The data format<.8, E ,
1
check: The
2:0dd parity
forrnat<8,0, 1 >
check: The
3: No
i the broadcast
1-247, s
o
to
subject system process i ng time,
The factory val u e
0 . 0 s (invalid )
O.HlilO.
set
3
data format<B,N,2>
data
data format<B-N-1 >
1
address
2ms
0
into is invalid.If, in
1 >