abc 2000 Series User Manual page 55

Voltage source fur V/F
separation
.
4 1
P
3
Setting
Range
Voltage digital setting for
V/F separation
P4.14
Setting Range
V/F separation is generally applicable to the occasions, such as
induction heating, inverse power supply and motor torque control.
If V/F separated control is enabled, the output voltage can be
function code P4.14 or by means of analog, multi-reference, simple
PLC, PID or communication. If you set the output voltage by means
of non-digital setting, 100% of the setting corresponds to the rated
motor voltage. If a negative percentage is set, its absolute value is
used as the effective value.
0: digital setting (P4.14)
The output voltage is set directiy by P4.14.
1 : FIV; 2:FIC
The output voltage is set by Al terminals.
3: Reserved
4: Pulse setting (S3)
The output voltage is set by pulses of the terminal 83.
Pulse setting specification: voltage range 9-30 V, frequency range
0-100 kHz
5: Multi-reference
If the voltage source is multi-reference, parameters in group P4
and PC must ba set to determine the corresponding relationship
between setting signal and setting voltage.
100.0% of the multi-reference setting in group FC corresponds to
the rated motor voltage.
6: Simple PLC
If the voltage source is simple PLC mode, parameters in group FC
Defaul t lo
0
1
FIV
2 FIC
Reserved
3
4
P ul
se
Multimreference
5
6 Simple
7 PID
Communication setting
8
100.0% corresponds to the rated motor volt.age(P2.02)
Default
setti
n g(S3)
PLC
OV-rated motor voltage
set
by