Running Slate; Standby Status - abc 2000 Series User Manual

nameplate parameters must be accurate, inverter will based
on nameplate parameters matching standard motor;ln order to
get better control performance, motor parameter auto-tuning is
suggested and auto-tuning steps are as follows:
First will run command channel choice (P2.00) choice for keyboard
commands.Then the actual parameters according to the motor,
please input the following parameters.
P2.00:the motor type;
P2.01: the motor rated power;
P2.02: the motor rated voltage;
P2.03: the motor rated current;
P2.04: the motor rated fi"equency;
P2.05: the motor rated speed.
In the process of self learning, the keyboard will display �study�,
when the keyboard display END.the motor parameter self learnings
is end.
Note: in the process of auto-tuning ,motor and load should be
released, otheiwise, the motor parameters obtained from the auto­
tuning may not
2: the static parameters of the self learning
Motor static parameters auto-tuning , don't need to release motor
with the load, motor parameter auto-tuning , must correct the
input para.meters
tuning will detect the motor stator resistance and rotor resistance
and leakage inductance of the motor.And mutual inductance of the
motor and no-load current will not be able to measure, the user can
input the corresponding values according to the motor nameplates.

3.3 Running slate

3.3.1 Power-on lnlllallzatlon
In the process of the Inverter's power-on, the system first initializes,
LED display for "2000", and seven lights all bright. After the
initialization is complete, the drive is in standby mode.

3.3.2 Standby status

In the stopping or running status, can display a variety of state
parameters. By Function Code P7.03 (operating parameters), P7.05
(stop parameter) binary bits , Various definitions can refer to P7.03
be correct.
of
motor nameplates (P2.01 - P2.05), since auto­