abc 2000 Series User Manual page 114

Restore defaul t setti n gs
PP. 0 1
Setti n g Ra
1 : Restore default settings except motor parameters
If FP-01 is set to 1 , most function codes are restored to the default
settings except motor parameters, frequency reference decimal
point {P0.22, fault records, accumulative running time (P7.09),
accumulative power-on time (P7.13) and accumulative power
consumption (P7.14).
2: Clear records
If PP.01 is set to 2, the fault records, accumulative running time
(P7.09). accumulative power-on time (P7.13) and accumulative
power consumption (P7. 14) are cleared.
501: Back up current set user parameters
Back up current set user parameters ,to back up all the current
parameter settings are backed up, helping you to restore the setting
if incorrect parameter setting is performed.
4: Restore user backup parameters
If PP.01 is set to 4, the previous backup user parameters are
restored.
Group CO: Torque Control and Restricting Parameters
Speed/Torque
sel e ction
co.co
Setti n g Range
It is used to select the AC drive's control mode: speed control or
torque control.
ABC-
The 2 000 provides S terminals with two torque related
functions, ITorque control p rohibited (f unction 29 )and Speed
control/Torque control switchover(function 46 )
terminals need to be used together with C0.00 to implement speed
control/torque control switchover.
Ii the S terminal allocated wi th function 46 (S peed controlfTorque
control switchover) is OFF, the control mode is determined by
0
1
ge
n
2
4
501
control
·109·
Detailed Function
Defaul t 1 0
No o erati o n
p
Restore factory setti ng s except motor
parameter s
records
Clear
Rest.ore user
backup
Back up cur r ent user parameters
Defaul t
Torque control
parameters
The two S
.