abc 2000 Series User Manual page 68

If the value of a certain digit is selected to 1 , when analog input
voltage is less than the minimum input,the corresponding value of
this analog input is 0.0° /o
X1 delay time
P5.35
Sotling Rango
X2
delay time
P5.36
Setting Range
X3
delay time
P5.37
Setting Rango
Thasa parameters are used to set the delay time of the AC drive
when the status of the terminal changes.
Currently, only FWD,REV and 81 support the delay time function.
S valid mode selection 1
P5.38
Setting Range digit
S valid mode selection
PS.39
Setting Range O
These parameters are used
The S terminal is valid when being connected with GND, and
invalid when being disconnected from GND.
The S terminal is invalid when being connected
valid when being disconnected from GND.
Group P&: Output Terminals
ABC2
The 000 provides 1 multi-function analog output terminal FOV,
f ro1 multi-function relay output terminal and a M01 terminal (used
high-speed pulse output or open-collector switch signal output) as
Default
Default
Unit's digit FWD valid mode
0
1 low level valid
REV
Ten's digit
Hundred's
S1
Thousand's
S2
Ten
thousand's S3 valid mode (0-1,sama as FWD)
2
Default
Unifs digit S4valid mode
1 low level valid
set digital input tenninals' valid mode .
to
Detailed Function
valid
valid mode (0-1,same as
valid mode (0-1,sama as FWD)
valid mode (0-1,same as FWD)
FWD)
wi'lh
GND, and