Detailed Function Description
Group PO: Basic Parameters
GIP
Setting Range
This parameter is used to display the delivered model and cannot
be modified.
1 :
Applicable to oonslanl torque load with rated parametera specified
2:
Applicable to variable torque load (fan and pump) with rated
parameters specified
Control mode selection
Pll.0 1
Seiling Range
O:
Voltage/Frequency (VIF) control
It is applicable to applications with low load requirements or
applications where one AC drive operates multiple motors, such as
fan and pump
1
:Sensorless flux vector control (SFVC)
It indicates open-loop vector control, and is applicable to high
performance control applications such as machine tool, centrifuge,
wire drawing machine and injection moulding machine. One AC
drive can operate only one motor.
Note: If vector control is used, motor auto-tuning must be performed
because the advantages
correct motor parameters are obtained. Better performance can be
achieved by adjusting the motor parameters.
Chapter4
type display
1
2
1
of
vector control can only be utilized after
Detailed Function
Model dependent
Default
G
P type (variable torque load e.g. fan and
u
p)
p
m
Default
Voltage/Frequency (V/F) control
Sensoriess flux vector
(SFVC}
control