abc 2000 Series User Manual page 69

standard.
P6.00 1-- - - - ---. - - - - - - -
P6.01 MO 1 function open-collector output termlnal
P6.02
These two parameters are used to select the functions of the five
digital output terminals. RA-RB-RC are respectively the relays
on the control board and the extension card. The functions of the
output terminals are described in the following table.
Table 4-5 Functions of output terminals
value Function
0 No output
1 AC drive running
Fault output
2
(stop)
Frequency-level
3 detection FDT1 Refer to the descriptions of P8.19 and P8.20.
Frequency
4
reached
Zero-speed
running
5
(no output at
Motor overload performing the protection action. If the pre-waming
6
pre-waming
AC drive
7 overload
Set count value The terminal outputs ON when the count value
8
reached
Designated
9 count
value reached
Length reached The terminal outputs ON when the detected actual
10
PLC cycle
11
complete
Relay output function (RA-RB-RC)
The terminal has no function.
When the AC drive is running and has output
When the AC drive stops due to a fault, the terminal
outputs ON.
Refer to the descriptions
If
the AC drive runs with the output frequency
the terminal outputs ON. If the AC drive is in the
stop state, the terminal outputs OFF.
The AC drive judges whether the motor load
exceeds the overload pre-warning threshold before
threshold is exceeded, the terminal outputs ON. For
motor overload parameters, see the descriptions of
P9.00 P9.02.
to
The terminal outputs ON 1 Os before the AC drive
overload protection action is performed.
reaches the value set in Pb.08.
The terminal outputs ON when the count value
reaches the value set in Pb.09.
length exceeds the value set in Pb.05.
When simple PLC completes one cycle, the terminal
outputs a pulse si g nal with width
·64·
Description
P8.21.
of
250
of
Default 0
Default 2
0,
of
ms.