abc 2000 Series User Manual page 108

multi-reference 7
PC. 0 7
Setting Range
O
multi-reference
PC.
B
Set.ting Range
multi-reference 9
PC.09
Setting Range
multi-reference
PC.10
Setting Range
mulliMrafarence
PC.11
Setting Range
m
l
mu ti
PC.12
Setting Range
multi-reference
PC.13
Setting Range
multiMraferenca
PC.14
Reference
PC.15
Setting Range
Multi-reference can be used in three occasions : as the source of
frequency, V/F separated voltage source and the setting source of
process PID. The multi-reference is relative value and ranges from
-100.0% lo 1 00.0%.
As
frequency source, it is a percentage relative to the maximum
frequency. As V/F separated voltage source, it is a percentage
relative to the rated motor voltage.
As
process PID setting source, it does not require conversion.
Multi-reference can be switched over based on different states of
multifunction digital S terminals. For details.see the descriptions of
group P5.
PLC
Simple
PC.16
Setting Range
0: Stop after the AC drive runs one cycle
The AC drive stops after running one cycle, and will not start up until
receiving another command.
1 : Keep final values after the AC drive runs one cycle
The AC drive keeps the final running frequency and direction after
running one cycle.
8
10
11
ref
12
n
re
e ce
13
14
15
running mode Default
0
1
2
Detailed Function
Default
m100.0%-100.0%
Default
-100.0%-100.0%
Default
-100.0%-100.0%
Default
m100.0%-100.0%
Default
-100.0%-100.0%
Default
-100.0%-100.0%
Default
m100.0%-100.0%
Default
-100.0%-100.0%
Default
-100.0%-100.0%
Stop after the
Keep final values after the
one cycle
after
Repeat the
·103·
runs one cvcle
AC drive
AC drive
runs one cvir:le
AC drive
runs