abc 2000 Series User Manual page 67

PULSE filter time
P5.32 >--- -- -- -�- --�- -- -- -- --<
Setting Range O.OOs-10.00s
These parameters are used to set the relationship between S3
pulse frequency input and corresponding settings. The pulses can
only be input by 83. The method of setting this function is similar to
that of setting Fl curve 1 ,Refer to the descriptions of Fl curve 1 .
F l curve selection
PS.33
Setting Range
The unifs digit, ten's digit and hundred's digit of this parameter are
respectively used to select the corresponding curve of FIV,FIC. Any
one curve of the five curves can be selected for 2 analog inputs.
Curve 1 , curve 2 and curve 3 are all 2-point curves, need to set in
group P5. Curve 4 and curve 5 are both 4-point curves, set in group
cs.
ABC2
The 000 provides
Setting
minimum inout
P5.34
Setting Range
This function code is used to determine the corresponding setting
when the analog input voltage is less than the minimum value.
The unit's digit, ten's digit and hundred's digit of this function oode
respectively c<>rra s pond to the setting for FIV,FIC and FIC.
If the value of a certain digit is selected to 0, when analog input
voltage is less than the minimum input, the corresponding setting of
the minimum input
Unifs digit FIV curve selection
1
2
3
4
5
Ten's dicit FIC curve selection (1-5, same as FIV)
Hundred's
digit
two
Fl tenninals as stendard.
Fl less than
for
Unit's digit Setting for FIV less than minimum input
0
1
Ten's digit
Hundred's
digit
(
P5.14, P5. 19, P5.24
Default 0.10s
Default
Curve 1 t2 points, see P5.13-P5.16)
Curve 2 (2 points, see P5.1 B-P5.21}
Curve 3 (2 points, see P5.23-P5.26)
Curve (4 points, see C6.00-C6.07)
4
Curve 5 (4 points, see C6.08-C6.15)
Reserved
Default
Minimum value
0.0%
Setting for FIC less than minimum input
(0-1, same as F!V)
Reserved
)
is used.