abc 2000 Series User Manual page 44

F
Stop mode
PUO
Setti n g Range 1 1 Coast to stop
O: Decelerate to stop
After the stop command is enabled, the AC drive decreases the
output frequency according to the deceleration time and stops when
the frequency decreases to zero.
1 : Coast to stop
After the stop command is enabled, the AC drive immediately stops
the output. The motor will coast to stop based on the mechanical
inertia.
I n iti a l frequency of stop Defaul t 1 0. 0 0Hz
DC braking
P1.11
Setti n g Range
Wai t i n g ti m e of stop DC Defaul t lo. O s
P1.12
Setti n g Range
P1.13 Stop DC braki n g current Defaul t lo%
Setti n g Range
P1.14 Stop DC braki n g ti m e Defaul t ID.Os
1
Pl 1 (Initial frequency of slop DC braking)
.
During the process of decelerating to stop, the AC drive starts DC
braking when the running frequency is lower than the value set in
P l . 1 1 .
P1.12 (Wailing time of stop D C braking)
When the running frequency decreases to the initial frequency of
'
ti
.....
i g u
re 4-2
S-curve
Detailed Function
' '
"
.... .
acce! e ratl o n/decel e ratl o n
Defaul t 10
O. O OHz-Maximum frequency
' ' '
- �
Time ( t )
0 "
A
O. O s-36. 0 s
0%•100%
O. O s-36. 0 s