abc 2000 Series User Manual page 120

FIV input corresponding setting varies betvleen 49.0% and 51 .0%.
II you set C6.16 to 50.0% and C6.17 to 1.0%, then the obtained
stable input FIV input corraaponding selling is fixed to 50.0% altar
the jump function, eliminating the fluctuation
Group CC: FllFO Correction
FIV measured voltage
CC.00
Setting Range
FIV dlspla\!l"ll d vo!rnine
CC.01
Setting Range
FIV measured voltage
CC.02
FIV displayed voltage
CC.03
Setting Range
FIC measured volt.ai:ie
CC.04
Setting Range
FIC displayed voltage
CC.05
FIC measured voltaae
CC.06
Setting Range
FIC displayed voltage
CC.07
These parameters are used
of Fl zero offset and gain.
They have been corrected upon delivery. When you resume the
factory values, these parameters will be restored to the factory­
corrected values. Generally, you need not perform correclion in the
applications.
Measured voltage indicates the actual output voltage value
measured by instruments such as the multimeter. Displayed voltage
indicates the voltage display value sampled by the AC drive. For
details, nafar to D0.21, D0.22 .During comaction, sand two voltage
values to each Fl terminal, and save the measured values and
displayed values to the function codes CC.00 to CC.07. Then
the AC drive will automatically perform Fl zero offset and gain
correction,
V
FO target voltage
CC.12
Setting Range
1
1
2
Default
2
1
1
2
2
to correct the Fl
1
Defautt
0.500V-4.000V
1
15
· ·
Detailed Function
effect.
Factory-corrected
Factory-corrected
Factory-corrected
Factory-corrected
Factory-correded
to eliminate the impact
Factory-corrected