abc 2000 Series User Manual page 77

module, and the
module depends on the model.
Temporary software version Default
p7 08
·
SetUn Ran
It is used to display the temporary software version of the control
board.
Accumulative running time
Pl.09
Setting Range
It is used to display the accumulative running time of the AC drive.
After the accumulative running time reaches the value set in P8.17,
the terminal with the digital output function 12 outputs ON.
P7.10
reserved
Software version
!'7.11
Sett i ng Range !Software version
Number of decimal
places for load spee d display
P7.12
Seiling Range
P7 .12 is used to set the number of decimal places for load speed
display. The following gives an example to explain how to calculate
the load speed:
Assume that P7.06 (load speed display coefficient) is 2.000 and
P7.12 is 2 (2 decimal places). When the running frequency of the
AC dlive is 40.00 Hz, the load speed is 40.00 x 2.000
012 decimal places).
If the AC drive is in the stop state, the load speed is the speed
corresponding to the set frequency, namely, "set load speed". If the
set frequency is 50.00 Hz, the load speed in tho stop state is 50.00
x 2.000 = 100.00 (display of 2 decimal places).
It is used to display the accumulative power-on time of the AC drive
since the delivery.
the terminal with the digital output function 24 outputs ON.
Accumulative power
pt i
n
P7.14
co m
s u
IGBT overheat protection value of the inverter
o.0°c-1 so. o �c
e
Oh-65535h
1
2
3
If
the time reaches the set power-on time (P8.17),
on
Read-only
Oh
Default
Default
Default
of control board
Default
0
decimal place
1
decimal place
2
decimal places
3
decimal plaC'Ss
Oh
80.00 (display
�