abc 2000 Series User Manual page 59

Value Function
24
Swing pause
25 Counter input This tenninal is used to count pulses.
26 Counter reset This tenninal is used to clear the counter status.
Length count This tenninal is used to count the length.
27
input
28 Length resat This tenninal is used to clear the length.
Torque control The AC drive Is prohibited from torque control and
29
prohibited
Pulse input
(enabled only S3 Is used for pulse Input.
30
for S3)
31 Reserved
Immediate DC After this tennlnal becomes ON, the AC drive
32
braking
Normally
closed (NC) After this tennlnal becomes ON, the AC drive
33
input of
external fault
Frequency
34 modification not respond to any frequency modification until this
forbidden
Reverse PIO
35 action
direction
External STOP
36
terminal 1
Command
source
37
switchover
terminal 2
PIO integral adjustment function pauses. However, the
38
pause
Switchover
betwee n main
frequency
39
source
and preset
frequency
The AC drive outputs the central frequency, and the
enters the speed control mode.
Reserved
directly switches over to the DC braking state.
reports E15 and stops.
If
this termlnal becomes effective , the AC drive will
tenninal becomes invalid.
After this tenninal becomes ON, the PID action
direction Is reversed to the direction set In PA.03.
In operation panel mode, this termlnal can be used
to stop the AC drive, equivalent to the function
key
the STOP
It Is used to perform switchover between terminal
control and communicetion control.
source is terminal control, the system will switch
over to communication control after this termlnal
becomes effective.
After this tenninal becomes elfective, the integral
proportional and differentiation adjustment functions
are still valid.
After this tenninal becomes alfective, the frequency
X
x
source is replaced by the preset frequency set in
P010.
·5
Description
on the operation panel.
4
·
of
If
the command