Fault Reset; Motor Parameter Self Leaming - abc 2000 Series User Manual

In three-level state,
code cannot be modified, possible reasons are:
1) The function code parameters can not be modffied.Such as the
actual testing parameters, operation records, etc.;
2) The function code in the running state cannot
ID
to stop modify;
3.2.2

Fault reset

After the failure of t h e inverter, t h e inverter will be prompted
to related fa.ult information.Users can press STOP key on t h a
keyboard o r terminal function
fa.ult reset, the inverter is in the standby state.If the inverter is in fault
state, the user does not carry on the fault reset, the inverter is in the
running to protect state, inverter can't run.
3.2.3 Motor parameter self learning
1 :The dynamic parameter self learning
Choosing no PG vector control operation mode, input motor
0 0 0 0
�tf� g
0 0 0 0
�t{� g
�ti! g
0 0 0 0
� g
0 0 0 0
00.00
g
Flow
chart
of
if the parameter is not flashing, said the function
0 0 0 0
0 0 0 0
� g
� g
parameter setting.
ID
conduct I h a fault reset (P5), after
be modified, need