abc 2000 Series User Manual page 34

2) When the auxiliary frequency source for analog input given (FIV,
FIC) or to the input pulse given, 1 00o/o of the input set corresponding
auxiliary frequency source range, can be set by P0.06 and P0.07.
3) 3) Whan Frequency source is pulse input given similar to analog
given. Tip: auxiliary frequency source selection and main frequency
source X, Y can� set lo the same channel, namely P0.04 and P0.05
can't set to the same value, otherwise it will be easy to cause
confusion.
Auxiliary frequency
source superposition
range selection
P0.06
Setting Range
Auxiliary frequency
source superposition
P0.07
Setting Range
When selecting frequency source for t h e superposition of
"frequency" (P0.03 sat to 1, 3, or 4), these
to determine the adjusting range of auxiliary frequency source.
P0.05 is used to determine the scope of the auxiliary frequency
source of the object, the choice of relative to the maximum
frequency, can also be relative to the rate of frequency source X,
if choice is relative to the main frequency source, the scope of the
secondary frequency source will change as the change of main
frequency X.
Acceleratlon time 1
P0.08
Setting Range
Decaleration time 1
P0.09
Acce l eration time refers to the inverter from zero, the deceleration
time needed for reference frequency (P0.24 determine).
Deceleration time refers to the inverter from benchmark frequency
(P0.24 determine), deceleration down to zero frequency time
required.
Frequency
preset
P0.10
Setting Range
When frequency source selection
DOWN", the function code value is the frequency of the inverter
digital set initial value.
Defaul t l o
Y
0 Relative
1 Relative
Defaul t l o
Y
Default
Default
Default
0.00 - maximum frequency (P0.12)
set
Detailed Function
lo the maximum frequency
to
the main frequency source
0%-150%
two
parameters are used
Model dependent
o.oos .. 65000s
Model dependent
o.oos-65000s
for "digital" or "terminal UP/
X