abc 2000 Series User Manual page 57

be used as a high-speed pulse input terminal), two analog input
terminals.
P5.00 FWD function selection Default 1 Forward RUN (FWD)
P5.01 REV function selectlon Default 2 Reverse RUN (REV!
P5.02
S 1 function selection
P5.03 S2 function selection Default 12 (Multi-reference terminal 1 )
P5.04
S3 function selectlon
P5.05
S4 function selection
The following table lists the functions available for the multi-function
input terminals.
Can choose the functions in the table as follows:
Value Function
0 No function
Forward RUN
1
(FWD)
Reverse RUN RUN
2
(REV)
Three-line
3
control
4
Forward JOG FJOG indicates forward JOG running, while RJOG
(FJOG)
Reverse JOG acceleration time and deceleration time are
5
(RJOG)
Terminal UP
6
7
Terminal
DOWN
8 Coast to stop rest and
9
Fault reset
(RESET)
10 RUN pause frequency and PIO parameters. After this function
Normally open
11 (NO) input
of external fault more details, see the description
Default
Default 13 (Multl-reference terminal 2)
Default 0
Set for reserved terminals to avoid malfunction.
O
The terminal is used to control forward or reverse
the AC drive.
of
The terminal determines three - line control
drive. For details, see the descriotion
indicates reverse JOG running. The JOG frequency,
described respectively in P8.00, P8.01 and P8.02.
If
the frequency is determined by external terminals,
the terminals with the two functions are used as
increment and decrement commands for frequency
modification. When the frequency source is digital
The AC drive blocks its output, the motor coasts to
is
not controlled
same as coast to stoo described in P1 .1
The terminal is used for fault reset function, the
same as the function
panel.Remote fault reset can be implemented by
this function.
The AC drive decelerates to stop, but the running
parameters are all memorized, such as PLC, swing
is disabled, the AC drive resumes its status before
If
this terminal becomes ON, the AC drive reports
E15 and performs the fault protection action. For
1
5
· ·
9
(Fault reset)
Description
of
by
the AC drive. It is the
of
RESET key on the operation
P9. 4 7.
of
the AC
of
P5.11.
o.