Connect Spectano 100 To The Dts1 Dielectric Test Sample Box - Omicron Lab SPECTANO 100 User Manual

Hide thumbs Also See for SPECTANO 100:

Table of Contents

9.5

Connect SPECTANO 100 to the DTS1 dielectric test

sample box

To test the functionality of SPECTANO 100 without a sample cell, connect SPECTANO 100 to the

DTS1 dielectric test sample box by using the delivered standard triaxial cables as shown in the

following figure.

Figure 9-6

DANGER

Death or severe injury caused by high voltage or current

► Before handling SPECTANO 100 in any way, connect its equipotential

ground terminal with a solid connection of at least 6 mm

and not longer than 20 meters to the ground terminal in the laboratory.

► Do not connect or operate SPECTANO 100 with a broken, dirty or

oxidized ground terminal or connection cables.

► Do not use power outlets without protective ground (PE).

► Only use the delivered AC power supply to power SPECTANO 100.

► Do not touch the output if the guard (inner shield of the triaxial

connection) is identical with the ground (outer shield of the triaxial

connection).

► Always ensure that no dangerous voltages are present at any touchable

part of the device or the DTS1 box.

For measuring on the Sample 2 connector, connect the blue-labeled cable to the Sample 2 connector.

Connecting SPECTANO 100 to the DTS1 dielectric test sample box for

measuring on the Sample 1 connector

cross-section

Installation

Table of Contents