Table of Contents
Advertisement
Table 10-12
Reference settings (continued)
Data
Noise suppression
Pre-measurement checks
Check for noise and
connectivity problems
Delay the start of the measurement until
The depolarization current
falls below
The time elapsed
1. Only available for test cells with disk electrodes
2. For the specified geometry of the electrodes, SPECTANO Analyzer Suite calculates the vacuum capacitance automatically. If you
select Others in the test cell settings, enter the vacuum capacitance manually.
3. Only available for the PDC and combined measurement modes selected in the sweep settings under Measurement mode.
4. Only available for the FDS and combined measurement modes selected in the sweep settings under Measurement mode.
The following table describes the measurement settings.
Table 10-13
Measurement settings
Data
General measurement settings
Temperature
Humidity
Material sample settings
Material type
Serial number
Sample thickness
1
Position A
1
Position B
1
Position C
1
Position D
Description
Select the Standard or Improved option for the
suppression of the noise interference. If you
select Improved, the noise-to-signal ratio and,
consequently, the measurement accuracy will be
improved but the measurement time will increase.
Select the
Check for noise and connectivity problems
check box to check for noise and connectivity
problems before starting a test.
3
Select this option and enter the threshold
depolarization current to delay the start of the
measurement until the depolarization current falls
below the threshold.
Select this option and enter the time limit to delay
the start of the measurement until the time limit
elapsed.
Description
Temperature of the test cell/sample
Environmental relative humidity
Type of the material sample
Serial number of the material sample
Sample thickness at position A
Sample thickness at position B
Sample thickness at position C
Sample thickness at position D
SPECTANO Analyzer Suite
57
Advertisement
Table of Contents
