SPECTANO 100 User Manual
Table 10-8
Result view controls (continued)
Control
Cursor table
Impedance calculation
Parallel circuit
Serial circuit
x-Axis
5
Xmax
Xmin
1.
Only available for material measurements
Only available for the PDC and combined measurement modes selected in the sweep settings under Measurement type.
2.
3.
Specific resistance and conductivity are only available for DSH 100 and Disk electrode test cell selection.
4.
The impedance calculation affects only the numerical measurement results Rp/Rs und Cp/Cs displayed in the table but not
the Bode diagram of R and X.
Only seen in the Chart result view PDC: Ipol and Idepol and the three Cole-Cole chart views.
5.
Note: Some result view controls are not available for all chart result views.
52
Description
4
Select the parallel equivalent circuit as dielectric
model.
Select the serial equivalent circuit as dielectric
model.
Select the maximum value of the right x-axis.
Select the minimum value of the right x-axis.