Power Up Spectano 100; Connect Spectano 100 To The Computer - Omicron Lab SPECTANO 100 User Manual

Hide thumbs Also See for SPECTANO 100:

Table of Contents

SPECTANO 100 User Manual

9.2

Power up SPECTANO 100

DANGER

Death or severe injury caused by high voltage or current

► Use only the delivered accessories and cables to ensure the safety

► Read the safety instructions in chapter 2 "Safety instructions" in this User

► Before powering up SPECTANO 100, ensure that

To power up SPECTANO 100 by using the delivered AC power supply:

1. Plug the DC output connector of the AC power supply into the DC power input on the

SPECTANO 100 rear panel (see Figure 6-2 "SPECTANO 100 rear view").

2. Connect the AC power supply with the power cable.

3. Plug the mains plug of the power cable into the power outlet.

4. Press the I/0 power switch on the SPECTANO 100 rear panel.

9.3

SPECTANO 100 communicates with the computer through USB interface (see chapter 4 "PC

requirements"). To connect SPECTANO 100 to the computer:

1. Connect the USB 2.0 or higher cable to the USB connector on the SPECTANO 100 rear panel.

2. Connect the USB cable to the USB connector of your computer by using the delivered USB 2.0

cable.

standard of SPECTANO 100.

Manual before powering up SPECTANO 100.

► a solid connection of at least 6 mm

20 meters is connected between its equipotential ground and any

ground connection in the laboratory.

► the whole test system is grounded properly.

► only the delivered grounded AC power supply DRA Supply is

connected.

► the test object is connected correctly.

cross-section and not longer than

Table of Contents