Table of Contents
Advertisement
SPECTANO 100 User Manual
13.7.4
Cable Analysis
For the analysis of a cable dielectric layer, select the test type Cylindrical electrode without Guard ring in
the SPECTANO Analyzer Suite software. Please note, that according to measurement accuracy,
repeatability or reporting for cables, different international standards are valid. The standards described
in this document are only valid for the analysis of dielectric and resistive properties of solid and liquid
insulating materials.
13.8
Other geometries
Select 'Other geometries' in the SPECTANO Analyzer Suite software in case of
•
Using for example
o
Unsymmetrical electrode arrangements
Non-contacting electrode arrangements
o
Finger electrodes
o
o
Sensors used for the determination of dielectric parameter as permittivity, tanδ,
capacitance, relative or electrical conductivity etc.
Customized setups which cannot be covered with the symmetrical electrodes
o
•
Analyzing, for example, the dielectric parameters of electronic components or HV --
components as rotor/stator bars.
13.8.1
Vacuum capacitance c
For the selection 'Other geometries' the vacuum capacitance c
There are two possibilities how to determine the vacuum capacitance of your measurement setup:
1. Calculation
2. Measurement using a LC meter or the SPECTANO 100
For the measurement you can use the SPECTANO 100 and the SPECTANO Analyzer Suite. Perform a
measurement with an inserted solid or liquid material sample.
Therefore,
1. Add a measurement to your SPECTANO 100 Analyzer Suite file
2. Name the added measurement 'c
3. Start the 'c0 determination' measurement
4. Perform a .csv export
5. Determine c
0
6. Enter the determined c
created for the analysis of your material.
86
determination'.
0
= Average of c'(f)
result into the SPECTANO 100 Analyzer Suite file which you have
0
0
will not be calculated automatically.
0
Advertisement
Table of Contents
