Table of Contents
Advertisement
Table 10-16
Command
Reference(s)
On the Reference(s) tab on the test view ribbon, SPECTANO Analyzer Suite
Tab
provides the following commands. This tab is only available for DSH 100, Disk and
Cylindrical electrodes selectable under Test cell settings.
Figure 10-8
Commands on the Measurement(s) tab (continued)
Description
Load from
Load the results from the device to the selected
device
measurement.
Note: The settings are not loaded. For more
information, see 10.10 "Load from the device".
Clone selected
Creates a copy of the selected material
measurement
measurement. Then a new material measurement
is added with the settings of the selected
measurement.
Remove
Removes the selected material measurement.
selected
The reference measurement results are
measurement
preserved.
Remove all
Removes all added material measurements and
measurements
adds a new measurement with default settings
and without results. The reference measurement
results are preserved.
Test view ribbon: Reference(s) tab
SPECTANO Analyzer Suite
61
Advertisement
Table of Contents
