Table of Contents
Advertisement
minutes to recharge the 12-volt
battery of your vehicle.
5
Open and close any of the doors
of your vehicle with the power
switch OFF.
6
Maintain the engine speed of
the second vehicle and start the
hybrid system of your vehicle by
turning the power switch to ON.
7
Make sure the "READY" indica-
tor comes on. If the indicator
does not come on, contact your
Toyota dealer.
8
Once the hybrid system has
started, remove the jumper
cables in the exact reverse
order from which they were con-
nected.
Once the hybrid system starts,
have the vehicle inspected at your
Toyota dealer as soon as possible.
■
Starting the hybrid system when
the 12-volt battery is discharged
The hybrid system cannot be started by
push-starting.
■
To prevent 12-volt battery dis-
charge
●
Turn off the headlights and the audio
system while the hybrid system is off.
●
Turn off any unnecessary electrical
components when the vehicle is run-
ning at a low speed for an extended
period, such as in heavy traffic.
■
When the 12-volt battery is
removed or discharged
●
Information stored in the ECU is
cleared. When the 12-volt battery is
depleted, have the vehicle inspected
at your Toyota dealer.
COROLLA CROSS HYBRID_Kouzui_GE
COROLLA CROSS HYBRID_OM_General_OM16537E
8-2. Steps to take in an emergency
●
Some systems may require initializa-
tion. (P.435)
■
When removing the 12-volt battery
terminals
When the 12-volt battery terminals are
removed, the information stored in the
ECU is cleared. Before removing the
12-volt battery terminals, contact your
Toyota dealer.
■
Charging the 12-volt battery
The electricity stored in the 12-volt bat-
tery will discharge gradually even when
the vehicle is not in use, due to natural
discharge and the draining effects of
certain electrical appliances. If the vehi-
cle is left for a long time, the 12-volt bat-
tery may discharge, and the hybrid
system may be unable to start. (The
12-volt battery recharges automatically
while the hybrid system is operating.)
■
When recharging or replacing the
12-volt battery
●
In some cases, it may not be possible
to unlock the doors using the smart
entry & start system when the 12-volt
battery is discharged. Use the wire-
less remote control or the mechanical
key to lock or unlock the doors.
●
The hybrid system may not start on
the first attempt after the 12-volt bat-
tery has recharged but will start nor-
mally after the second attempt. This is
not a malfunction.
●
The power switch mode is memorized
by the vehicle. When the 12-volt bat-
tery is reconnected, the system will
return to the mode it was in before the
12-volt battery was discharged.
Before disconnecting the 12-volt bat-
tery, turn the power switch off.
If you are unsure what mode the
power switch was in before the 12-volt
battery discharged, be especially
careful when reconnecting the 12-volt
battery.
●
Vehicles with power back door: The
power back door must be initialized.
(P.123)
411
8
Advertisement
Table of Contents
