Table of Contents
Advertisement
sure about 1 to 5 minutes after
the switch is turned on.
Turn the compressor switch off and
then check the tire inflation pressure.
Being careful not to over inflate, check
and repeat the inflation procedure until
the specified tire inflation pressure is
reached.
The tire can be inflated for about 5 to 20
minutes (depending on the outside tem-
perature). If the tire inflation pressure is
still lower than the specified point after
inflation for 25 minutes, the tire is too
damaged to be repaired. Turn the com-
pressor switch off and contact your
Toyota dealer.
If the tire inflation pressure exceeds the
specified air pressure, let out some air
to adjust the tire inflation pressure.
(P.396, 424)
15With the compressor switch off,
disconnect the hose from the
valve on the tire and then pull
out the power plug from the
power outlet socket.
Some sealant may leak when the hose
is removed.
16Install the valve cap onto the
valve of the emergency repaired
tire.
17Attach the air release cap to the
end of the hose.
If the air release cap is not attached,
the sealant may leak and the vehicle
COROLLA CROSS HYBRID_Kouzui_GE
COROLLA CROSS HYBRID_OM_General_OM16537E
8-2. Steps to take in an emergency
may get dirty.
18Temporarily store the bottle in
the luggage compartment while
it is connected to the compres-
sor.
19To spread the liquid sealant
evenly within the tire, immedi-
ately drive safely for about 5 km
(3 miles) below 80 km/h (50
mph).
20After driving, stop your vehicle in
a safe place on a hard, flat sur-
face and reconnect the repair
kit.
Remove the air release cap from the
hose before reconnecting the hose.
21Turn the compressor switch on
and wait for several seconds,
395
8
Advertisement
Table of Contents
