Toyota COROLLA CROSS HYBRID 2020 Owner's Manual page 196

194
4-5. Using the driving support systems
WARNING
■
When to disable the pre-colli-
sion system
In the following situations, disable the
system, as it may not operate prop-
erly, possibly leading to an accident
resulting in death or serious injury:
●
When the vehicle is being towed
●
When your vehicle is towing
another vehicle
●
When transporting the vehicle via
truck, boat, train or similar means of
transportation
●
When the vehicle is raised on a lift
with the hybrid system on and the
tires are allowed to rotate freely
●
When inspecting the vehicle using
a drum tester such as a chassis
dynamometer or speedometer
tester, or when using an on vehicle
wheel balancer
●
When a strong impact is applied to
the front bumper or front grille, due
to an accident or other reasons
●
If the vehicle cannot be driven in a
stable manner, such as when the
vehicle has been in an accident or
is malfunctioning
●
When the vehicle is driven in a
sporty manner or off-road
●
When the tires are not properly
inflated
●
When the tires are very worn
●
When tires of a size other than
specified are installed
●
When tire chains are installed
●
When a compact spare tire or an
emergency tire puncture repair kit is
used
COROLLA CROSS HYBRID_Kouzui_GE
COROLLA CROSS HYBRID_OM_General_OM16537E
●
If equipment (snow plow, etc.) that
may obstruct the radar sensor or
front camera is temporarily installed
to the vehicle
Changing settings of the
pre-collision system
■ Enabling/disabling the pre-col-
lision system
The pre-collision system can be
enabled/disabled on
of the multi-information display.
The system is automatically enabled
each time the power switch is turned to
ON.
If the system is disabled, the PCS
warning light will turn on and a
message will be displayed on the
multi-information display.
■ Changing the pre-collision
warning timing
The pre-collision warning timing
can be changed on
the multi-information display.
The warning timing setting is retained
when the power switch is turned off.
However, if the pre-collision system is
disabled and re-enabled, the operation
timing will return to the default setting
(P.432)
(P.432) of