224
4-5. Using the driving support systems
WARNING
●
Keep the sensors and the sur-
rounding areas on the rear bumper
clean at all times.
If a sensor or its surrounding area on
the rear bumper is dirty or covered
with snow, the Blind Spot Monitor may
not operate and a warning message
(P.222) will be displayed. In this sit-
uation, clear off the dirt or snow and
drive the vehicle with the operation
conditions of the BSM function
(P.226) satisfied for approximately
10 minutes. If the warning message
does not disappear, have the vehicle
inspected by your Toyota dealer.
●
Do not attach accessories, stickers
(including transparent stickers), alu-
minum tape, etc. to a sensor or its
surrounding area on the rear
bumper.
●
Do not subject a sensor or its sur-
rounding area on the rear bumper
to a strong impact.
If a sensor is moved even slightly
off position, the system may mal-
function and vehicles may not be
detected correctly.
In the following situations, have
your vehicle inspected by your
Toyota dealer.
• A sensor or its surrounding area is
subject to a strong impact.
• If the surrounding area of a sensor
is scratched or dented, or part of
them has become disconnected.
COROLLA CROSS HYBRID_Kouzui_GE
COROLLA CROSS HYBRID_OM_General_OM16537E
●
Do not disassemble the sensor.
●
Do not modify the sensor or sur-
rounding area on the rear bumper.
●
If a sensor or the rear bumper
needs to be removed/installed or
replaced, contact your Toyota
dealer.
●
Do not paint the rear bumper any
color other than an official Toyota
color.
Turning the Blind Spot Moni-
tor on/off
Use the meter control switches to
turn on/off the function.
1
Press
or
to select
2
Press
or
to select
and then press
.
.